Linux Audio

Check our new training course

Loading...
/*
 * Copyright (c) 2023 STMicroelectronics
 *
 * SPDX-License-Identifier: Apache-2.0
 */

#include <st/f0/stm32f051.dtsi>

/ {
	clocks {
		clk_hsi48: clk-hsi48 {
			#clock-cells = <0>;
			compatible = "fixed-clock";
			clock-frequency = <DT_FREQ_M(48)>;
			status = "disabled";
		};
	};

	soc {
		compatible = "st,stm32f071", "st,stm32f0", "simple-bus";

		flash-controller@40022000 {
			flash0: flash@8000000 {
				erase-block-size = <2048>;
			};
		};

		pinctrl: pin-controller@48000000 {
			gpioe: gpio@48001000 {
				compatible = "st,stm32-gpio";
				gpio-controller;
				#gpio-cells = <2>;
				reg = <0x48001000 0x400>;
				clocks = <&rcc STM32_CLOCK(AHB1, 21U)>;
			};
		};

		/*
		 * USARTs 3-4 share the same IRQ on stm32f071xx devices. This
		 * configuration is not currently supported, so at most one of
		 * these may be enabled at a time. Enabling more than one will
		 * result in a build failure.
		 */
		usart3: serial@40004800 {
			compatible = "st,stm32-usart", "st,stm32-uart";
			reg = <0x40004800 0x400>;
			clocks = <&rcc STM32_CLOCK(APB1, 18U)>;
			resets = <&rctl STM32_RESET(APB1, 18U)>;
			interrupts = <29 0>;
			status = "disabled";
		};

		usart4: serial@40004c00 {
			compatible = "st,stm32-usart", "st,stm32-uart";
			reg = <0x40004c00 0x400>;
			clocks = <&rcc STM32_CLOCK(APB1, 19U)>;
			resets = <&rctl STM32_RESET(APB1, 19U)>;
			interrupts = <29 0>;
			status = "disabled";
		};

		timers7: timers@40001400 {
			compatible = "st,stm32-timers";
			reg = <0x40001400 0x400>;
			clocks = <&rcc STM32_CLOCK(APB1, 5U)>;
			resets = <&rctl STM32_RESET(APB1, 5U)>;
			interrupts = <18 0>;
			interrupt-names = "global";
			st,prescaler = <0>;
			status = "disabled";
		};

		dma1: dma@40020000 {
			interrupts = <9 0 10 0 10 0 11 0 11 0 11 0 11 0>;
		};
	};
};