Loading...
# LPCXpresso55S69 board # Copyright (c) 2019, NXP # SPDX-License-Identifier: Apache-2.0 if BOARD_LPCXPRESSO55S69_CPU0 || BOARD_LPCXPRESSO55S69_CPU1 config BOARD default "lpcxpresso55S69_cpu0" if BOARD_LPCXPRESSO55S69_CPU0 default "lpcxpresso55S69_cpu1" if BOARD_LPCXPRESSO55S69_CPU1 config FXOS8700_DRDY_INT1 default y depends on FXOS8700_TRIGGER # For the secure version of the board the firmware is linked at the beginning # of the flash, or into the code-partition defined in DT if it is intended to # be loaded by MCUboot. If the secure firmware is to be combined with a non- # secure image (TRUSTED_EXECUTION_SECURE=y), the secure FW image shall always # be restricted to the size of its code partition. # For the non-secure version of the board, the firmware # must be linked into the code-partition (non-secure) defined in DT, regardless. # Apply this configuration below by setting the Kconfig symbols used by # the linker according to the information extracted from DT partitions. # Workaround for not being able to have commas in macro arguments DT_CHOSEN_Z_CODE_PARTITION := zephyr,code-partition config FLASH_LOAD_SIZE default $(dt_chosen_reg_size_hex,$(DT_CHOSEN_Z_CODE_PARTITION)) depends on BOARD_LPCXPRESSO55S69_CPU0 && TRUSTED_EXECUTION_SECURE if TRUSTED_EXECUTION_NONSECURE || BOARD_LPCXPRESSO55S69_CPU1 config FLASH_LOAD_OFFSET default 0x50000 if !TFM_BL2 default $(dt_chosen_reg_addr_hex,$(DT_CHOSEN_Z_CODE_PARTITION)) config FLASH_LOAD_SIZE default 0x40000 if !TFM_BL2 default $(dt_chosen_reg_size_hex,$(DT_CHOSEN_Z_CODE_PARTITION)) endif # TRUSTED_EXECUTION_NONSECURE || BOARD_LPCXPRESSO55S69_CPU1 choice TFM_PROFILE_TYPE depends on BUILD_WITH_TFM default TFM_PROFILE_TYPE_MEDIUM endchoice endif # BOARD_LPCXPRESSO55S69_CPU0 || BOARD_LPCXPRESSO55S69_CPU1 if DMA_MCUX_LPC # Memory from the heap pool is used to allocate DMA descriptors for # channels that use multiple blocks for a DMA transfer. # Adjust HEAP_MEM_POOL_SIZE in case you need more memory. config HEAP_MEM_POOL_SIZE default 4096 endif # DMA_MCUX_LPC |