Loading...
/* * Copyright (c) 2018 Intel Corporation * * SPDX-License-Identifier: Apache-2.0 */ #include <kernel.h> #include <init.h> #include <drivers/pinmux.h> #include "iomux.h" /* * :::::::::::: NOTE :::::::::::: * For a list of possible I/O MUX settings, * See soc/xtensa/intel_s1000/iomux.h */ /* * Initializes the I/O MUX with the setting needed per Intel S1000 CRB * For customizations, please refer to the table above for available settings * Please note that a call to pinmux_pin_set is only needed when a setting * that is not default is required */ static int intel_s1000_pinmux_init(const struct device *dev) { const struct device *pinmux; pinmux = DEVICE_DT_GET(DT_INST(0, intel_s1000_pinmux)); __ASSERT_NO_MSG(device_is_ready(pinmux)); if (!device_is_ready(pinmux)) { return -ENXIO; } /* Select PDM instead of I2S0 since board has 8 microphones */ pinmux_pin_set(pinmux, PIN_GROUP(I2S0), PINMUX_FUNC_B); /* * I2S3 is wired to the host interface connector. * Select GPIO to avoid any conflict with hosts that may be driving * the signals. */ pinmux_pin_set(pinmux, PIN_GROUP(I2S3), PINMUX_FUNC_B); /* TI DAC is on I2C1. Usually, there is no device on I2C0 */ pinmux_pin_set(pinmux, PIN_GROUP(I2C), PINMUX_FUNC_B); /* Intel S1000 CRB has an octal SPI flash. Select MST_DQ */ pinmux_pin_set(pinmux, PIN_GROUP(EM_DQ), PINMUX_FUNC_B); return 0; } SYS_INIT(intel_s1000_pinmux_init, PRE_KERNEL_2, CONFIG_PINMUX_INIT_PRIORITY); |