/*
* Copyright (c) 2018 Prevas A/S
*
* SPDX-License-Identifier: Apache-2.0
*/
#include <init.h>
#include <drivers/pinmux.h>
#include <fsl_port.h>
static int frdm_k22f_pinmux_init(const struct device *dev)
{
ARG_UNUSED(dev);
#if DT_NODE_HAS_STATUS(DT_NODELABEL(porta), okay)
__unused const struct device *porta =
DEVICE_DT_GET(DT_NODELABEL(porta));
__ASSERT_NO_MSG(device_is_ready(porta));
#endif
#if DT_NODE_HAS_STATUS(DT_NODELABEL(portb), okay)
__unused const struct device *portb =
DEVICE_DT_GET(DT_NODELABEL(portb));
__ASSERT_NO_MSG(device_is_ready(portb));
#endif
#if DT_NODE_HAS_STATUS(DT_NODELABEL(portc), okay)
__unused const struct device *portc =
DEVICE_DT_GET(DT_NODELABEL(portc));
__ASSERT_NO_MSG(device_is_ready(portc));
#endif
#if DT_NODE_HAS_STATUS(DT_NODELABEL(portd), okay)
__unused const struct device *portd =
DEVICE_DT_GET(DT_NODELABEL(portd));
__ASSERT_NO_MSG(device_is_ready(portd));
#endif
#if DT_NODE_HAS_STATUS(DT_NODELABEL(porte), okay)
__unused const struct device *porte =
DEVICE_DT_GET(DT_NODELABEL(porte));
__ASSERT_NO_MSG(device_is_ready(porte));
#endif
#if DT_NODE_HAS_STATUS(DT_NODELABEL(uart0), okay) && CONFIG_SERIAL
#error "No UART0 is used"
#endif
#if DT_NODE_HAS_STATUS(DT_NODELABEL(uart1), okay) && CONFIG_SERIAL
/* UART1 RX, TX */
pinmux_pin_set(porte, 0, PORT_PCR_MUX(kPORT_MuxAlt3));
pinmux_pin_set(porte, 1, PORT_PCR_MUX(kPORT_MuxAlt3));
#endif
#if DT_NODE_HAS_STATUS(DT_NODELABEL(uart2), okay) && CONFIG_SERIAL
/* UART2 RX, TX */
pinmux_pin_set(portd, 2, PORT_PCR_MUX(kPORT_MuxAlt3));
pinmux_pin_set(portd, 3, PORT_PCR_MUX(kPORT_MuxAlt3));
#endif
#if DT_NODE_HAS_COMPAT_STATUS(DT_NODELABEL(ftm0), nxp_kinetis_ftm_pwm, okay) && CONFIG_PWM
/* Red, green, blue LEDs as PWM channels*/
pinmux_pin_set(porta, 1, PORT_PCR_MUX(kPORT_MuxAlt3));
pinmux_pin_set(porta, 2, PORT_PCR_MUX(kPORT_MuxAlt3));
pinmux_pin_set(portd, 5, PORT_PCR_MUX(kPORT_MuxAlt4));
#endif
#if DT_NODE_HAS_STATUS(DT_NODELABEL(spi0), okay) && CONFIG_SPI
/* SPI0 CS0, SCK, SOUT, SIN */
pinmux_pin_set(portc, 4, PORT_PCR_MUX(kPORT_MuxAlt2));
pinmux_pin_set(portd, 1, PORT_PCR_MUX(kPORT_MuxAlt2));
pinmux_pin_set(portd, 2, PORT_PCR_MUX(kPORT_MuxAlt2));
pinmux_pin_set(portd, 3, PORT_PCR_MUX(kPORT_MuxAlt2));
#endif
#if DT_NODE_HAS_STATUS(DT_NODELABEL(i2c0), okay) && CONFIG_I2C
/* I2C0 SCL, SDA */
pinmux_pin_set(portb, 2, PORT_PCR_MUX(kPORT_MuxAlt2)
| PORT_PCR_ODE_MASK);
pinmux_pin_set(portb, 3, PORT_PCR_MUX(kPORT_MuxAlt2)
| PORT_PCR_ODE_MASK);
#endif
return 0;
}
SYS_INIT(frdm_k22f_pinmux_init, PRE_KERNEL_1, CONFIG_PINMUX_INIT_PRIORITY);