# Kconfig - DHT Temperature and Himidity Sensor configuration options # # Copyright (c) 2016 Intel Corporation # # Licensed under the Apache License, Version 2.0 (the "License"); # you may not use this file except in compliance with the License. # You may obtain a copy of the License at # # http://www.apache.org/licenses/LICENSE-2.0 # # Unless required by applicable law or agreed to in writing, software # distributed under the License is distributed on an "AS IS" BASIS, # WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. # See the License for the specific language governing permissions and # limitations under the License. # menuconfig DHT bool prompt "DHT Temperature and Humidity Sensor" depends on SENSOR && GPIO default n help Enable driver for the DHT temperature and humidity sensor family. choice prompt "Chip type" depends on DHT default DHT_CHIP_DHT11 help Choose desired chip type from the DHT family. config DHT_CHIP_DHT11 bool prompt "DHT11" help Choose this option to enable the DHT11 chip. config DHT_CHIP_DHT22 bool prompt "DHT22" help Choose this option to enable the DHT22 chip. endchoice config DHT_NAME string prompt "Driver name" default "DHT11" if DHT_CHIP_DHT11 default "DHT22" if DHT_CHIP_DHT22 depends on DHT help Device name with which the sensor is identified. config DHT_GPIO_DEV_NAME string prompt "GPIO device" default "GPIO_0" depends on DHT help The device name of the GPIO device to which the chip's data pin is connected. config DHT_GPIO_PIN_NUM int prompt "Interrupt GPIO pin number" default 0 depends on DHT help The number of the GPIO on which the chip's data pin is connected.