# Kconfig - drivers configuration options for SeeedStudio Grove Devices # # Copyright (c) 2015 Intel Corporation # # Licensed under the Apache License, Version 2.0 (the "License"); # you may not use this file except in compliance with the License. # You may obtain a copy of the License at # # http://www.apache.org/licenses/LICENSE-2.0 # # Unless required by applicable law or agreed to in writing, software # distributed under the License is distributed on an "AS IS" BASIS, # WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. # See the License for the specific language governing permissions and # limitations under the License. # menuconfig GROVE bool prompt "Grove Device Drivers" default n help Check this box to enable the Seeed Grove device drivers config SYS_LOG_GROVE_LEVEL int prompt "Grove Log level" depends on SYS_LOG && GROVE default 0 range 0 4 help Sets log level for Grove Device Drivers. Levels are: 0 OFF, do not write 1 ERROR, only write SYS_LOG_ERR 2 WARNING, write SYS_LOG_WRN in adition to previous level 3 INFO, write SYS_LOG_INF in adition to previous levels 4 DEBUG, write SYS_LOG_DBG in adition to previous levels config GROVE_LCD_RGB bool default n depends on GROVE prompt "Enable the Seeed Grove LCD RGB Backlight" help Setting this value will enable driver support for the Groove-LCD RGB Backlight. config GROVE_LCD_RGB_I2C_MASTER_DEV_NAME string "I2C Master where Grove LCD is connected" depends on GROVE_LCD_RGB default "I2C0" help Specify the device name of the I2C master device to which the Grove LCD is connected. config GROVE_LCD_RGB_INIT_PRIORITY int prompt "Init priority" default 70 depends on GROVE_LCD_RGB help Device driver initialization priority. As the device is connected to I2C bus, its driver has to be initialized after the I2C one.