Loading...
/* * Copyright (c) 2018 Christian Taedcke * * SPDX-License-Identifier: Apache-2.0 */ #ifndef __INC_BOARD_H #define __INC_BOARD_H #include <soc.h> /* Push button PB0 */ #define PB0_GPIO_NAME CONFIG_GPIO_GECKO_PORTF_NAME #define PB0_GPIO_PIN 6 /* Push button PB1 */ #define PB1_GPIO_NAME CONFIG_GPIO_GECKO_PORTF_NAME #define PB1_GPIO_PIN 7 /* LED 0 */ #define LED0_GPIO_NAME CONFIG_GPIO_GECKO_PORTF_NAME #define LED0_GPIO_PORT LED0_GPIO_NAME #define LED0_GPIO_PIN 4 /* LED 1 */ #define LED1_GPIO_NAME CONFIG_GPIO_GECKO_PORTF_NAME #define LED1_GPIO_PIN 5 /* Push button switch 0. There is no physical switch on the board with this * name, so create an alias to SW3 to make the basic button sample work. */ #define SW0_GPIO_NAME PB0_GPIO_NAME #define SW0_GPIO_PIN PB0_GPIO_PIN /* This pin is used to enable the serial port using the board controller */ #define BC_ENABLE_GPIO_NAME CONFIG_GPIO_GECKO_PORTA_NAME #define BC_ENABLE_GPIO_PIN 5 #endif /* __INC_BOARD_H */ |