Loading...
# Kconfig - USB device configuration options # # Copyright (c) 2016 Wind River Systems, Inc. # # SPDX-License-Identifier: Apache-2.0 # if USB config USB_DEVICE_DRIVER bool default n config USB_DW bool prompt "Designware USB Device Controller Driver" select USB_DEVICE_DRIVER default n help Designware USB Device Controller Driver. config USB_DW_IRQ_PRI int "DesignWare USB Driver Interrupt priority" depends on USB_DW help USB interrupt priority. config USB_DC_STM32 bool prompt "USB device controller driver for STM32 devices" depends on SOC_FAMILY_STM32 select USB_DEVICE_DRIVER select USE_STM32_LL_USB if !SOC_SERIES_STM32F0X && !SOC_SERIES_STM32F3X && !SOC_SERIES_STM32L0X select USE_STM32_HAL_PCD select USE_STM32_HAL_PCD_EX select HAS_DTS_USB default n help Enable USB support on the STM32 F0, F1, F3, F4, L0 and L4 family of processors. config USB_DC_SAM0 bool prompt "SAM0 series USB Device Controller driver" depends on SOC_FAMILY_SAM0 select USB_DEVICE_DRIVER default n help SAM0 family USB device controller Driver. config USB_NRF52840 bool prompt "Nordic Semiconductor nRF52840 USB Device Controller Driver" depends on SOC_NRF52840 select USB_DEVICE_DRIVER select HAS_DTS_USB default n help nRF52840 USB Device Controller Driver config USB_KINETIS bool prompt "Kinetis USB Device Controller Driver" select USB_DEVICE_DRIVER default n help Kinetis USB Device Controller Driver. config SYS_LOG_USB_DRIVER_LEVEL int prompt "USB driver log level" depends on SYS_LOG default 0 help Sets log level for USB driver Levels are: - 0 OFF, do not write - 1 ERROR, only write SYS_LOG_ERR - 2 WARNING, write SYS_LOG_WRN in addition to previous level - 3 INFO, write SYS_LOG_INF in addition to previous levels - 4 DEBUG, write SYS_LOG_DBG in addition to previous levels config USB_DC_STM32_DISCONN_ENABLE bool depends on USB_DC_STM32 default n help Say Y if your board uses USB DISCONNECT pin to enable the pull-up resistor on USB DP. endif # USB |