Linux debugging
Check our new training course
Linux debugging, tracing, profiling & perf. analysis
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48
CONFIG_ARM=y CONFIG_BOARD_OLIMEXINO_STM32=y CONFIG_SOC_FAMILY_STM32=y CONFIG_SOC_SERIES_STM32F1X=y CONFIG_SOC_STM32F103XB=y CONFIG_CORTEX_M_SYSTICK=y # 72MHz system clock CONFIG_SYS_CLOCK_HW_CYCLES_PER_SEC=72000000 # enable uart driver CONFIG_SERIAL=y CONFIG_UART_STM32=y # enable USART1 CONFIG_UART_STM32_PORT_1=y # enable console on this port by default CONFIG_CONSOLE=y CONFIG_UART_CONSOLE=y # enable I2C driver CONFIG_I2C=y CONFIG_I2C_STM32_V1=y # enable pinmux CONFIG_PINMUX=y CONFIG_PINMUX_STM32=y # enable GPIO ports A, B, C, D CONFIG_GPIO=y CONFIG_GPIO_STM32=y CONFIG_GPIO_STM32_PORTA=y CONFIG_GPIO_STM32_PORTB=y CONFIG_GPIO_STM32_PORTC=y CONFIG_GPIO_STM32_PORTD=y # clock configuration CONFIG_CLOCK_CONTROL=y # Clock configuration for Cube Clock control driver CONFIG_CLOCK_STM32_HSE_CLOCK=8000000 CONFIG_CLOCK_STM32_SYSCLK_SRC_PLL=y # use HSE as PLL input CONFIG_CLOCK_STM32_PLL_SRC_HSE=y # produce 72MHz clock at PLL output CONFIG_CLOCK_STM32_PLL_XTPRE=n CONFIG_CLOCK_STM32_PLL_MULTIPLIER=9 CONFIG_CLOCK_STM32_AHB_PRESCALER=1 # APB1 clock must not to exceed 36MHz limit CONFIG_CLOCK_STM32_APB1_PRESCALER=2 CONFIG_CLOCK_STM32_APB2_PRESCALER=1