Loading...
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 101 102 103 104 105 106 107 108 109 110 111 112 113 114 115 116 117 118 119 120 121 122 123 124 125 126 127 128 129 130 131 132 133 134 135 136 137 138 139 140 141 142 143 144 145 146 147 148 149 150 151 152 153 154 155 156 157 158 | /*
* Copyright 2002-2005, Instant802 Networks, Inc.
* Copyright 2005-2006, Devicescape Software, Inc.
*
* This program is free software; you can redistribute it and/or modify
* it under the terms of the GNU General Public License version 2 as
* published by the Free Software Foundation.
*/
/*
* This regulatory domain control implementation is known to be incomplete
* and confusing. mac80211 regulatory domain control will be significantly
* reworked in the not-too-distant future.
*
* For now, drivers wishing to control which channels are and aren't available
* are advised as follows:
* - set the IEEE80211_HW_DEFAULT_REG_DOMAIN_CONFIGURED flag
* - continue to include *ALL* possible channels in the modes registered
* through ieee80211_register_hwmode()
* - for each allowable ieee80211_channel structure registered in the above
* call, set the flag member to some meaningful value such as
* IEEE80211_CHAN_W_SCAN | IEEE80211_CHAN_W_ACTIVE_SCAN |
* IEEE80211_CHAN_W_IBSS.
* - leave flag as 0 for non-allowable channels
*
* The usual implementation is for a driver to read a device EEPROM to
* determine which regulatory domain it should be operating under, then
* looking up the allowable channels in a driver-local table, then performing
* the above.
*/
#include <linux/module.h>
#include <linux/netdevice.h>
#include <net/mac80211.h>
#include "ieee80211_i.h"
static int ieee80211_regdom = 0x10; /* FCC */
module_param(ieee80211_regdom, int, 0444);
MODULE_PARM_DESC(ieee80211_regdom, "IEEE 802.11 regulatory domain; 64=MKK");
/*
* If firmware is upgraded by the vendor, additional channels can be used based
* on the new Japanese regulatory rules. This is indicated by setting
* ieee80211_japan_5ghz module parameter to one when loading the 80211 kernel
* module.
*/
static int ieee80211_japan_5ghz /* = 0 */;
module_param(ieee80211_japan_5ghz, int, 0444);
MODULE_PARM_DESC(ieee80211_japan_5ghz, "Vendor-updated firmware for 5 GHz");
struct ieee80211_channel_range {
short start_freq;
short end_freq;
unsigned char power_level;
unsigned char antenna_max;
};
static const struct ieee80211_channel_range ieee80211_fcc_channels[] = {
{ 2412, 2462, 27, 6 } /* IEEE 802.11b/g, channels 1..11 */,
{ 5180, 5240, 17, 6 } /* IEEE 802.11a, channels 36..48 */,
{ 5260, 5320, 23, 6 } /* IEEE 802.11a, channels 52..64 */,
{ 5745, 5825, 30, 6 } /* IEEE 802.11a, channels 149..165, outdoor */,
{ 0 }
};
static const struct ieee80211_channel_range ieee80211_mkk_channels[] = {
{ 2412, 2472, 20, 6 } /* IEEE 802.11b/g, channels 1..13 */,
{ 5170, 5240, 20, 6 } /* IEEE 802.11a, channels 34..48 */,
{ 5260, 5320, 20, 6 } /* IEEE 802.11a, channels 52..64 */,
{ 0 }
};
static const struct ieee80211_channel_range *channel_range =
ieee80211_fcc_channels;
static void ieee80211_unmask_channel(int mode, struct ieee80211_channel *chan)
{
int i;
chan->flag = 0;
if (ieee80211_regdom == 64 &&
(mode == MODE_ATHEROS_TURBO || mode == MODE_ATHEROS_TURBOG)) {
/* Do not allow Turbo modes in Japan. */
return;
}
for (i = 0; channel_range[i].start_freq; i++) {
const struct ieee80211_channel_range *r = &channel_range[i];
if (r->start_freq <= chan->freq && r->end_freq >= chan->freq) {
if (ieee80211_regdom == 64 && !ieee80211_japan_5ghz &&
chan->freq >= 5260 && chan->freq <= 5320) {
/*
* Skip new channels in Japan since the
* firmware was not marked having been upgraded
* by the vendor.
*/
continue;
}
if (ieee80211_regdom == 0x10 &&
(chan->freq == 5190 || chan->freq == 5210 ||
chan->freq == 5230)) {
/* Skip MKK channels when in FCC domain. */
continue;
}
chan->flag |= IEEE80211_CHAN_W_SCAN |
IEEE80211_CHAN_W_ACTIVE_SCAN |
IEEE80211_CHAN_W_IBSS;
chan->power_level = r->power_level;
chan->antenna_max = r->antenna_max;
if (ieee80211_regdom == 64 &&
(chan->freq == 5170 || chan->freq == 5190 ||
chan->freq == 5210 || chan->freq == 5230)) {
/*
* New regulatory rules in Japan have backwards
* compatibility with old channels in 5.15-5.25
* GHz band, but the station is not allowed to
* use active scan on these old channels.
*/
chan->flag &= ~IEEE80211_CHAN_W_ACTIVE_SCAN;
}
if (ieee80211_regdom == 64 &&
(chan->freq == 5260 || chan->freq == 5280 ||
chan->freq == 5300 || chan->freq == 5320)) {
/*
* IBSS is not allowed on 5.25-5.35 GHz band
* due to radar detection requirements.
*/
chan->flag &= ~IEEE80211_CHAN_W_IBSS;
}
break;
}
}
}
void ieee80211_set_default_regdomain(struct ieee80211_hw_mode *mode)
{
int c;
for (c = 0; c < mode->num_channels; c++)
ieee80211_unmask_channel(mode->mode, &mode->channels[c]);
}
void ieee80211_regdomain_init(void)
{
if (ieee80211_regdom == 0x40)
channel_range = ieee80211_mkk_channels;
}
|